Tundra Remote Door Lock Reprogram

Turn the ignition to on and then back to off and remove the key from the ignition.

Tundra remote door lock reprogram.

Within 3 seconds the door locks should lock and then unlock once indicating successful programming. Repeat steps a and b in step 6 for each new remote. The locks should cycle once to verify that the car has accepted your remote. While there is the possibility of a pretty big electrical issue most of the problems are minor and easy to fix.

Using the door control pad located on the driver s side door press the lock and unlock buttons once again for five passes. Press the lock button by itself and hold for 2 seconds. If not start again at step 1. Close the driver s door.

This is the best and easiest fix. Luckily the toyota tundra power door locks are pretty easy to self diagnose what s wrong. Repeat button procedure to program remaining remote transmitters. System should now lock and unlock vehicle once to confirm registration twice to indicate registration has failed.

If you have done everything correctly within three seconds the door locks should lock then unlock automatically. Insert your key into the ignition switch and put it in the run position. Press and release lock or unlock button. If the door locks cycle twice repeat steps a and b in step 6 as the remote was not accepted.

Once your car is in programming mode with the remote you are trying to program press the unlock and lock buttons simultaneously for about 2 seconds then release and press just the lock button for 1 second. Press and hold lock and unlock button for 1 5 seconds. Each set represents one pass.